I’ve always wondered how I would trim the excess t-molding that pokes out above and below the edges of the timber. I tried using a really super-sharp chisel on the control panel and it worked, but you could see the marks for each different cut. Not too happy with the result.
I just did some searching and I found a tool called an “edge trimmer”. I am going to have to get one.
[UPDATE: Couldn’t help myself – I just ordered one from mcjing about 5 minutes after writing this blog entry]
Looks like they are available from a variety of places:
I got a few hours to myself this afternoon so I got a few things done to the arcade machine that I have been dying to do for ages.
T-molding on control panel: Managed to get some t-molding attached to the control panel.
T-molding on top half sides: I really worked hard on taking my time doing this as I have learned from experience that cutting the slots requires a bit of concentration to ensure that the slot-cutter does not wander from the centre line. You can see that I did not concentrate hard enough – I had to use a bit of duct tape to fatten up a small section of the t-molding to ensure a snug fit.
Tools: You need a few tools to get this right:
- ear muffs: so the router doesn’t make you deaf
- rubber mallet: to bang the t-molding into the slot. I once tried it just by using the heel of my hand – not a good idea – hurts too much the next day. Followed that up with a standard hammer – not a goo idea – marks the t-molding. Get a rubber mallet.
- clamps: to stop the timber moving when cutting slots and banging in t-molding
- gloves: to protect my dainty hands from splinters
- pencil: mark out where the starting point of the t-molding. When I pull it out to paint the timber I know the exact point to put the t-molding. Yay for thinking ahead.
- t-molding: to make your timber pretty and comfortable.
- router: to cut slots. My router is adjustable from about 22,000 rpm to 32,000 rpm. Cut slots as slow as possible – otherwise flaming timber is the result…
- chisel: I needed this to help bang in the t-molding on the internal corne. (In the pic the corner I am talking about is between the duct tape and the utility knife). The handle of the chisel had a diamater that matched the curvature of the corner, and was also coated in rubbery material that would not damage the t-molding.
- duct tape: if you make your slot to big you can use some duct-tape to fatten up the bottom of the ‘T’ to make a snug fit.
- screwdriver: toaid in the removal of the t-molding
- utility knife: cut little wedgesfrom the base of the t-molding so going around corners does not crimp the t-molding.
Removed speakers from the TV: It took me ages to pull the back off the tv, remove the speakers, av-inputs and back-plane and chop off the speakers from the sides of the TV.
I am going to lengthen the wires from the tv to the speakers and mount them above the TV – behind or below the marquee.